Ok first off how concentrated is your test e? Some batches just don't want to go over 300mgs per. Really enanthate just has this issue where batches don't get fully properly cleaned when they finish the manufacturing process. Basically carbolic acids get leftover in the finished raw. The good news is you can boil/evaporate off the excess carbolic acids. All you need to do is put your raw and only your raw into the carrier oil then just heat to around 220-230 f while stirring and hold it at that temp for about half a hour. That should address most PIP unless you are just going super high with your concentrations like 400mgs per. If you want to brew high concentrations of long estered test then do half enanthate and half cypionate. I don't know why this is easier to brew and hold a painless product vs pure enanthate but it does.
FYI if you do end up doing a blend of enanthate and cypionate at high concentrations then I would increase your bb percentage to 16-20% depending on how high your concentration is.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.