Eq @ 500mg/ml

napsgearhttps://ugloz.is/ domestic-supplypuritysourcelabsYOURMUSCLESHOPUGFREAK
I landed some Eq thats 500mg/ml, I guess it was one of those impulse buys that women get. Now I got thinking about it, is Eq at a ratio that high going to pack a punch(pain)? Also scored some Test thats 300mg/ml, whatcha think about that? This sounds like a questiong for Mr. Brew! Right now Im using BD's Andropen 275 and its packing a little heat to be honest, just wandering if swithing to the Test/Eq is going to be any better on my body.

Note to self:
Taking 1,000 mgs of Ibuprofen before a leg workout to mask the inj. pain in your quad will only make matter worst when the medicine wears off.
 
Yeah bro.... Well, if you look at it this way: Its Test E @ 300mg/ml and Eq @ 500mg/ml. SO:
1cc of Test E and .5cc of Eq= 1.5cc inject 2x per week will give you 600 Test E and 500 Eq/week. BEAUTIFUL match up.
Yeah its from a UG Lab, if it wasnt such a good deal I prolly wouldnt have messed with it. The guy is pretty good and all his gear is dosed high, he must know what hes doing. I think he said the Test E's BA is @ 2%... whatever that means.
 
SoCo....i like that too...i really do like the higher dosages of test when your mixing them with EQ it is usually painless....i like mixing eq and deca with test....especially when im usuing propionate...that shit hurts
 
I hope it doesnt hurt. Im sitting here right now with a lump in my left quad that not only hurts, but its red and warm. I swear this BD gear is killing me! Im sort of reluctant to put this stuff back in my body. I know its not staph(this time), but what gives? The first few injects werent so bad, but it seems like they are getting worst everytime, like my body is rejecting it, when usually they only get better.
 
Hey southern , I got the same 500mg/ml EQ from etl also , I haven't used it yet as i'm still using BD EQ which is absolutely painless , i'm gonna shoot the 500mg EQ on monday. I'll let you know how it goes.
 
I really don't know man. Eq and test E are both oil soluble so the solvent conc tend to be low, but at that high mg it maybe quite painful. I had a batch of test E adn eq at 330/200 per ml and it crippled me. The solvent percentage was low so it was rather unexpected, after that I tend to stay away from such high mg gear as it does tend to painful. If it gets that bad, just cut it with some sterile oil and bring it down to 250 and its will be painless.
 
I think that one big probelms with any gear that is highly concentrated is that the AAS may fall out of suspension and then you get crystals. Those HURT to inject. If it is cloudy, just warm it up. 250 mg/ml of test doesn't hurt, so I don't think that popping it up to 300 mg/ml would cause that much pain, but I know that some folks report a lot of pain with higher dosed test ("super test"). Dunno about eq.

The other way to go is to MIX the gear with oil like brew suggests. Or if you also using something like masteron at 100 mg/ml, just mix that in the pin and it will cut things.

Also, be sure to rub the injection site for a minute shortly after you inject. This helps with pain.
 
I want someone to stick it in themselves, I'm getting impatient...I can't wait til Monday bytista, lmao, jk, let us know how it goes on Tuesday morning, lol./
 
LOL, check this.... this is the responce I got when I asked if the gear what painless, what does this mean to you?
"I can guarantee the EQ to be painless as i have used the 450 EQ i
made b4 And a 275 cyp which was also painless. I haven't used the
Test-E from this run But none of my gear contains over 2.2% ba.
The only reason my Test-E is over 2% is due to the fact that after
filtration, ".22um of course", The batch did not clarify 100%.
This was due to the moisture content of the powder I use. It is
fresh-off-the line. I had to heat it slightly until it clarified,
not over 180*, Then refiltered."*copied and pasted*

Brew, what in the hell does all this mean?
 
I've been using the 400mg/ml EQ from ProM. Anywhoo, I actaully use it to cut the Prop/Tren 100/100 mix that I got from him as well. It is very painless, so I can't imagine going 100 more mg/ml is going to make it terribly painful.
 
be careful with dropping names here guys nobody has done anything wrong but just be careful....I have used BD eq as well and i think its great, no pain at all.......It sounds like there might be some sterility issues if that keeps on getting red like that....keep us posted and see if things get better
 
I think its sterile... Im just getting adverse reactions to it. I dont know what the deal is. I did a delt and calve today, if it gets bad Ill let yall know. But all in all, Im growing like a week. BD is good gear, no doubt, I think my body is just acting weird. But no doubt, Im gettin bigger, up a total of 0 lbs!!! BUT, Im noticably bigger, harder, more vascular and a lot stronger. Im only putting down 3500 cals and 300gs of protein per day. This should be a nice lean cycle!
 
Well I shot the EQ 500mg/ml today and wow it was absolutely painless. I've been using all BD Gear so far and i always have slight pain while injecting and minor soreness a few hours later , but i felt no pain at all or have any soreness with this EQ. Anyone else try EQ @ 500mg/ml yet? Cause i'm a little worried , I mean shouldn't i feel something at this type of high concentration?
 
Back
Top