Quad injects?

M

mikeswift

New member
OK I've been doing ED injects and mixing it up between my glutes and my quads but I never really feel comfortable picking a spot to shoot in my quad. What are the guidelines for Quad injects? I'm hitting the side about 5 inches above my knee... can anyone give me some guidelines to follow? and where to stay away from... I like quad injects so much better than glutes because I have better control and I can see what I'm doing
 
Yeah me too I just did quad injectlast night and it is too difficult to do properly in my opinion. I really could't pull-out the plundger a bit to see if I was inj. into a vein... Scary !

I'm starting alt. quad inj.
Check out www.musclereview.com They have pics, instructuions, ect.

Good luck Bro'
 
what works for me- measure a hand's length from the hip and a hand's length from the knee. The open area in between on the outside of the quad is the area you have to inject in. Watch for veins...
 
irishpride said:
www.spotinjections.com
a newbie bible for injection advice
Click to expand...

bump, good site. I put edge of my palm on my hip bone and the other hand fingers on the knee cap. I find that its more painful the close you get to the bottom hand, but I usually hit veins more often when I go this high.
 
I've got long legs too mmx2 so I know what you mean... thanks for all the replies boys. Seems like I was shooting in the general vicinity of where I should be but nice to have some good guidelines.:D
 
when I first started I also did a practice run with the cap on to get the angle, and pin in the right most comfortable situation.

peace
 
I inject pretty high up on my quads. If I reach around and feel the bottem of my ass cheek and them draw a line over to my quad thats about the right height. It seems to cause less muscle soreness for me.
 
Exactly the place I inject, when you do it lower it hurts more in my experience cuz the muscle becomes smaller as you go down the leg. I never hit a vein or ligaments lol those must hurt!
 
I've never done quads before. All my pins are 1 1/2", and I am trying to finish a box of 100 of them. You need 1" pins for quads, right? That was a good post for the inject technique--kudos to irishpride.
 
i agree that higher is better but don't get too close to the hip. on the side about 1/3 down for me works great

by the way to use 1 1/2 " pins here is a tip. take a needle cover and snip the end off with scissors so when u put it on the pin 1" shows. Works great
 
it's always better to stick it in your ass. It is the biggest muscle and you will get the best results this way.
 
Hey Tony, little trick I was taught. If you got 1 1/2 inchers and want to go 1 inch. Take the plastic sleve cut it alittle more than 1/2 way then slide it back over the pin....you got you self a spacer. I buy al my pins 1 1/2 or 1 but down size them this way depending where they are going.


Yeah I guess I should have read sundevils post first. Either way, convient little trick.
 
Last edited:
You must log in or register to reply here.

Similar threads

Muscle Insider
Mike O’Hearn Joins Breon Ansley’s Quad Training During His 2024 Arnold Classic Prep
Replies
0
Views
87
Muscle Insider
Muscle Insider
Muscle Insider
Classic Physique Bodybuilder Mike Sommerfeld’s Warm-Up and Quad Day Recommendations
Replies
0
Views
254
Muscle Insider
Muscle Insider
Muscle Insider
Wellness Bodybuilder Chloe Pickford Shares How to Build “Whammy” Quads 
Replies
0
Views
67
Muscle Insider
Muscle Insider
Muscle Insider
The Best 8 Stretches to Do Before a Run, According to a CPT
Replies
0
Views
64
Muscle Insider
Muscle Insider
Muscle Insider
The Best Running Warm-Up for Your Next Cardio Session
Replies
0
Views
54
Muscle Insider
Muscle Insider
Back
Top