Brew(about primo ace and solvents)

[So-Solid]

well you were right mate.Its a bitch this stuff aint it.I Tried it with 2.5%BA/and 18%BB.Crashed 5 mins after the conversion.Im a bit unsure as to wether to up the ba or add more bb.What do you think??.Ive never made anything with this much solvent in it before so im a bit concerned tbh.What if i have to go upwards of 20% to get it in solution.Is there a point where BB is going to turn into a problem-instead of being helpful

Appreciate your views on this bro...id hate to have to bin the whole lot.It cost me a fair chunk.

 

[brew]

Well I beleive flex claims to have shot pure bb and said it wasn't bad. I would up the ba to 4 and go from there.......what mg/ml you making.........you gotta aim low with this stuff its stubborn.....I would go 50-75 myself.

 

[So-Solid]

ive done it at 100mg/ml.Ill adjust the ba and see how it goes.if that dont work ill start pushing the BB up and see what happens.This could turn into a costly experiment i think....hope it doesnt. :crap:

If i have to adjust the solvent ratios and it starts going into silly figures......what do you think of me adding more oil instead......so it would be 100mg/2ml instead.Thatd thin it out and cut it down wouldnt it?

 

[brew]

thats what I would do bring up the solvents to the highest conc you are willing to go.........if that don't work then thin it down to 75-50 and then make sure to calculate the amount of solvents at that mg/ml and subtract from what you already added. Good luck

 

[So-Solid]

Quick update for anyone whos interested.Got it to hold at 4%BA and 20%BB.Its sat for 4 days now and still looks good.Dunno whats its like for pain yet though but ill tell ya when ive tried it out.
Later peeps.
SS

 

[brew]

good, now i just hope after all that trouble it doesn't put you down like it did me

 

[brew]

so what was the final concentraton?

 

[So-Solid]

100mg/ml bro.

 

[bushidobadboy]

Somebody (who it has to be said knows a thing or two about brewing - he runs a UG lab) said to me that methenolone ace is unsuitable for conversion into injectable format. He did not explain why, so I'm askin'...

Is it unsuitable simply because it requires a high conc. of solvents? If this is the case, I have to say I'm a little confused as I made up a batch (before I spoke to this guy) @ 100mg / ml with 2% BA + 20 % BB, with absolutely no problems at all. Been injecting it now for 2 days...

bushboy