Hello everyone,
since this is my first post on here I'll give a brief intro of myself. 26 in a few days, training seriously since 20, last 2-3 years started using.
Currently not in my best shape - Weigh 109kg height 186cm BF up to 20% atm (sorry about the metrics
prefer dry stuff as I bloat easily. Don't like EQ and havent tried primo yet, dont do orals much either.
going to brew for my first time and could use some hints from you. I have done a good bit of homework and decided to go with long esters for starters as they seem easier to hold.
I plan to go test, tren and mast all of them enanthate esters and @ 250mg/ml. I understand that the tren and mast will be harder to hold but though that at this concentration should be fine.
Would a 'standard' 2% BA 20% BB recipe hold this with carrier oil (will go with safflower USP grade)? If not, what should I adjust?
If needed I was thinking of doing a mix of 80% carrier oil 20% EO or even 50:50.
A second question as well - Im quite curious about trying out with slin pins (obviously for places with low BF). What kind of solution would make the above flow through?
My assumption would be that at least some EO would be needed, but how much? Or would heating the oil pre-inject suffice?
Thanks!
since this is my first post on here I'll give a brief intro of myself. 26 in a few days, training seriously since 20, last 2-3 years started using.
Currently not in my best shape - Weigh 109kg height 186cm BF up to 20% atm (sorry about the metrics
prefer dry stuff as I bloat easily. Don't like EQ and havent tried primo yet, dont do orals much either.
going to brew for my first time and could use some hints from you. I have done a good bit of homework and decided to go with long esters for starters as they seem easier to hold.
I plan to go test, tren and mast all of them enanthate esters and @ 250mg/ml. I understand that the tren and mast will be harder to hold but though that at this concentration should be fine.
Would a 'standard' 2% BA 20% BB recipe hold this with carrier oil (will go with safflower USP grade)? If not, what should I adjust?
If needed I was thinking of doing a mix of 80% carrier oil 20% EO or even 50:50.
A second question as well - Im quite curious about trying out with slin pins (obviously for places with low BF). What kind of solution would make the above flow through?
My assumption would be that at least some EO would be needed, but how much? Or would heating the oil pre-inject suffice?
Thanks!