Test Cyp / Deca Stack - FEEDBACK NEEDED

napsgearhttps://ugloz.is/ domestic-supplypuritysourcelabsYOURMUSCLESHOPUGFREAK

BreacherUp

Full Access
In an attempt to spare you the boredom here is my situation and my question(s)...

I am 34, 6'2", recently 225 at about 14%bf. I grew up skinny so maintaining size has always been important to me and I was not real concerned with getting ultra lean, as I was never fat. I have thrown on a decent amount of size naturally lifting over the past 20 years or so.

Traditionally, my workouts have always consitsted of HEAVY, HEAVY weights with longer rest intervals between sets. Recently I got talked into moving to a higher rep, shorter rest, HIIT type workout with a ultra clean eating program for 12 weeks. I am now about 205lbs at 8%bf+/-. I am lean but feel way smaller and that freaks me out. Not really what I am after.

Lately I had not been feeling like my old ball of fire self. My job is very demanding physically and mentally as I work on an elite recon team. Packing lots of gear, weaponry and constantly being mentally fatigued takes a toll on you... And I think it was taking its toll on me!

Per a friends suggestion, I had bloodwork done and was found to have low T high E (at the time of the first test - keep reading). I was prescribed the following (which is still sitting on my counter - unopened):

Test Cyp 200mg/wk
Deca 200mg/wk
HCG 500IU (2x / wk)
B12 - 1ml (3x / wk)
Arimidex 1mg (5x / wk)

From the research I have done over the past few years this seems like a fairly solid stack. Also, as you have probably figured this is HRT so the theory is I am supposed to stay on it indefinately with minor tweaks based on how I feel and bloodwork.

As far as my bloodwork, this is the interesting part. During this cutting phase I was on, I decided to stack H-Drol and EpiDrol together for six weeks (2 Methyls...Yes I know). I did not really notice anything from it. However, during my sixth week I went and had my bloodwork done and my Total Test was at 252 and Estradiol was at 65.3, this was what yielded me the above HRT recommendation. (Horrible Lipids - HDL/LDL results). I figured this had to be a result of the Hdrol/Epi because there was no way I was decently muscular with that high of E and that low of T. (My own opinion).

So I decided to wait two weeks later, which was also two weeks into my PCT and I got another blood test done. I also had taken (4) 1mg doses of Arimidex during the week prior to this second blood test which I wish I had not done because I am not sure if my body readpated naturally or the Arimidex kicked things into gear. I have a feeling it was the Armidex being very effective since Armidex has the capability to smash estrogen and as a result raise T by 50% or so. Anyway, the second blood test resulted at Total Test 402 and Estradiol 12.3. Far diffrent than two weeks prior.

I started taking th Arimidex to get myself in a good spot for the HRT I was about to begin not necessarily for PCT but I am sure it helped. I did not do blood lipids this time so I am not sure if my Lipds/Cholesterol were back in check or not.

I have decided to finish out my cutting program (2 more weeks) and then take one week off to rest. Then I plan to start the HRT program I have listed above while going on more of a clean bulk diet - more calories - mostly clean.


My questions finally...

1) Are the low T/E scores in my 6th week of my Hdrol/Epidrol cycle a result of the Hdrol/EpiDrol? Will they cause the low T / High E results I got?

2) How long post Hdrol/Epidrol cycle does it take for HDL LDL levels to normalize again? My diet is super clean, eating 6x day, multi's, Niacin, plenty of fish and Omegas, etc.

2.5)(2) Would it be a waist to start my HRT now knowing that I am going to be taking one week off after I complete the next two week phase of my current plan? Or would I benefit even further with the increased recovery being on cycle with one week off.

3) How does the above HRT stack sound? What results can I expect with excellent diet and the utmost workout intensity?

4)Any other comments or feedback would be much appreciated.
<!-- / message -->
 
Last edited:
Well first Welcome to MuscleChemistry bro! And I will skip down to your 2nd number 2 question,lol. Yes I think it would be a waist and I think you should wait to start the hrt cycle until after your break.

Question 3, Its a solid cycle bro especialy if your testosterone is low, 200mg cyp weekly will yeild great results bro, raise your energy levels as well! You can expect to pack on some decent muscle gains with proper diet and training.

As for your first question and your first number 2 question,lol, i will leave that to others who know about this
 
Hey Presser, thanks for the feedback. As eager as I am to get things moving I agree waiting until I am on track with the new plan and higher calories sounds like the best move. Also, I want to get 3-4 more weeks of nothing in my system so i can get bloodwork done just before I start and use that as a baseline. So I think waiting will serve several good purposes. Thanks again!


PS... I changed Question 2 to 2.5. LOL...
 
Hey Presser, thanks for the feedback. As eager as I am to get things moving I agree waiting until I am on track with the new plan and higher calories sounds like the best move. Also, I want to get 3-4 more weeks of nothing in my system so i can get bloodwork done just before I start and use that as a baseline. So I think waiting will serve several good purposes. Thanks again!


PS... I changed Question 2 to 2.5. LOL...

lol, 2.5 will work just fine, lol. No problem brutha!
 
Welcome to MuscleChemistry bro, as for your questions I don't have enough experience but hang out there are some experienced cats on here. Presser being one of them.
 
1. Im guessing that would be correct...alot of estrogen conversion

2. honestly I couldnt say, im guessing about 3-4 weeks though...maybe less since they are oral products

3. wait a bit and get everything in order...just train hard, eat correct. and you wont lose anything...

4. your hrt cycle sounds fine. I personaly would only do .5mg Arimadex 3 x a week, once your estrogen levels are in the normal range again. Also, to pack on the mass faster and more solid. I would bump up the test to 400mg after the 3 week to about the 6-8 week. Then taper down to 200mg again. The HCG will further enhance your gains to, as that will keep your natural test levels nice and high....

good luck
 
Great info and thanks for the reply Chris. Yes, once the E levels are in check, the plan is to back the Adex off to .5 grams. Good call.


***Side question... So I am new to injecting but have done a substantial amount of homework so that I get it right and do things safely and sanitarily...

Anyway, I want to know the best way to combine the Test Cyp and the Deca in one syringe. They are both oils so combining them should not be an issue that I can foresee. That being said is there any issue with cross contamination drawing from the Test Cyp and Deca vials with the same drawing needle (assuming everything is kept clean)? I dont want to contaminate things if a bit of the Test Cyp gets into the Deca vial - is this an issue?

Part two... If I am drawing out 1ml, I know I need to add at least 1ml (or 1.5 mg possibly) of air to the vial in order to help with the vacuum process of getting the oil into the syringe. If I load the syringe with 1 gram of air and then put it into the vial and draw out 1mg of Test then how do I add air to the second vial if I plan to mix them? Do I start out with 2ml of air add 1 to the Test, draw out 1mg and then keep the syringe upside down and inject the second 1ml of air into the Deca vial and then draw out the 1ml of Deca, effectively leaving me with 2ml's of oil (1ml Test / 1ml Deca) inside the syringe? Is there a better way. I am trying to cut down on the number of injections and I dont think injecting 2ml of oil at one time is overboard by any means...

Is there a flaw in my logic here?
 
1. Yes
2. 4-6 weeks
2.5 I would start as soon as you have everything in order. It will take a few weeks for you to notice anything from the long AAS esters. Your bodies hormone production is shit, so take it into your own hands and get it where you want it ASAP.
3. I used that cycle w/o Adex or HCG for YEARS and made great solid size and strength gains. Time is more important than dose ESPECIALLY since this is your first time. I would expect you to feel like a new man at about 4 weeks in and it will only get better as the Deca gets in about week 6.
I've found Deca to be most effective with very high protein diets. Say 300g a day for someone your size.
 
Dude, thank you very much for taking the time to reply. Great info and very helpful.

Now if I can just get some closure on my injecting multiple oils in one shot question I will be in good shape. (Post #7)

Thanks!
 
I am going to move the injection question to its own thread so this one does not get too far off topic. Thanks again for all the great information.
 
As far as contaminating I wouldn't think so, I have a buddy who mixes his test and eq in 10 ml vials and draws from there, now I'm not real hip on that because I personally like to know what and how much of what I'm getting but to each their own.
 
I like your idea of adding air to both vials first and then drawing the oil into one syringe after. That sounds like the best method I have head thus far. Thanks!
 
I realy think your way over thinking the drawing process brutha, No need to add air to anything unless im totaly missing something here, i draw the gear out then i stick the pin in 2nd bottle of different compound and draw more out, none ever seeps back into the other and if it did, it would be minimal* and wouldn't make a difference to the point of rendering the gear no good or degrading it any.
 
Okay makes sense. I just thought you had to add as much air volume into the vial as you are removing in terms of oil. From what I have read if you dont the vacuum process of extracting the oil into the syringe takes a long time due to the atmospheric pressure or lack of inside the vial.
 
Okay makes sense. I just thought you had to add as much air volume into the vial as you are removing in terms of oil. From what I have read if you dont the vacuum process of extracting the oil into the syringe takes a long time due to the atmospheric pressure or lack of inside the vial.

I never noticed any difference brutha, but hey maybe if i try it your way it will work better , you never know , as you learn something new everyday.
 
I like your idea of adding air to both vials first and then drawing the oil into one syringe after. That sounds like the best method I have head thus far. Thanks!
No problem, and it does work better to add the air other wise your fighting the pressure in the vial.
 
No problem, and it does work better to add the air other wise your fighting the pressure in the vial.

hmmm never done this nor have i ever heard of adding air before pulling the gear out, and never had any problem drawing it out before, but what ur saying is it will draw out faster and easier due to the pressure pushing it out into the pin?
 
Here is the info I learned when I started, pulled from this post: http://www.musclechemistry.com/upload/musclechemistry-discussion/45533-newbs-gear.html

Step 3
Remove the needle guard from the needle and syringe, saving the needle guard. Be sure you are using a proper syringe for intramuscular injections. Pull back on the syringe plunger to draw up an amount of air equal to the amount of medication that your doctor has prescribed for injection. For example, if you want to inject 2ccs of oil, then pull back 2ccs of air.

Step 4
Holding the vial of medication in an upright position, insert the needle straight through the center of the rubber stopper in the vial. Then push the plunger to discharge all the air into the vial.

Step 5
With the needle in the vial, turn the vial upside down and hold it in one hand. The tip of the needle should be in the solution. Using your free hand, pull the plunger back in a slow, continuous motion until you have drawn into the syringe the amount of medication that your doctor has prescribed.
 
Okay makes sense. I just thought you had to add as much air volume into the vial as you are removing in terms of oil. From what I have read if you dont the vacuum process of extracting the oil into the syringe takes a long time due to the atmospheric pressure or lack of inside the vial.

That's what I do, if I'm pulling 2cc out, I put 2cc worth of ait in there
 
Back
Top